PALMisLIFE 討論區
標題:
[求助] Palm能否把PC的C移植過來 ??
[列印本頁]
作者:
andy2000a
時間:
2004-11-3 07:31
標題:
[求助] Palm能否把PC的C移植過來 ??
有沒人會寫電路設計軟體給palm用
我是 circuit design .. 先前找到似 orcad tool --> pDraft ..
所以想到 那為何 palm 上沒 circuit simulator ?? 而且現在 treo600 / 650
CPU 都不慢 應該比較 80286 那時快多 應該可以有 simulator 吧
所以想把 spice 轉到 palm 上 因為有時出門在外 想分析簡單電路
都沒法分析 ..
那能否把 一些網路上 free source code 的 spice software 轉到 palm 上 ?
不用很強 只要能算些 簡單電路就夠用 , 因為 palm 上 word 好像沒法使用
方程式 所以如果分析電路 就只能看書上公式 用手解拉
那能否把 C source code 轉到 palm 上
http://www.ics.ee.nctu.edu.tw/~jtwu/cnote/Int/aic01-idx.html
free source code
http://www.geda.seul.org/source.html
-> linux spice source
NG-SPICE Circuit Simulator(与SPICE兼容的晶体管仿真软件)
http://ieee.ing.uniroma1.it/ngspice/
http://www.huihoo.com/forum/viewthread.php?tid=6971
由於多是 C 那是否可以 用 pocketC 重做一個 simulator ..
好像都沒看到 palm 上有 解電路的軟體
不過 spice 須要解一堆 matrix 可能對 Palm 比較難 而且很慢
但有種 switch level simulator 就是先把
mosfet 先建立 table , 查表方式去跑快很多 -> hsim , aditspice(sbtspice)
starsim 比較不準 但是快很多 ..
我在 linux 上使用 hspice & aditspice(hsim ) 使用 switch level 快 20多倍
歡迎光臨 PALMisLIFE 討論區 (http://f.pil.tw/)
Powered by Discuz! X2.5