3. Turn the camera OFF.
While pressing [PLAY]+[OK], Turn the camera ON.
You can see firmware version on LCD screen.
4. Firmware version is appeared,
then press [Fn]->[Fn]->[INFO]->[MENU] within 5 seconds.
You get service menu!!!
5. by pressing [right key]
,Make DEBUG MODE to DEBUG MODE .
then press [OK].
(save and LCD will be black out)
6. Press [MENU] and go to SETUP tab.
then, Press [Up key], you can see TEST MODE.
7. Select AF TEST menu. now you have AF correction menu.
If you have Front-focusing, reduce the value.
If you have back-focusing, increase the value.
after adjust some value, press [OK] and quit out of setup menu.
8. TEST for focus, find out that focus is correct.
(repeat this from 6 for correct focus.)
9. Go to service menu(step 3,4).
Make DEBUG MODE to DEBUG MODE .
then press [OK].(save and LCD black out)
STEP
1. Power OFF
While pressing [AE-L]+[INFO], turn the camera on.
Firmware is desplayed on LCD.
Press [MENU]->[MENU]->[INFO] within 5 seconds.
You can see DEBUG mode screen.
By pressing [Right key],Make [DEBUG MODE DIS] to [DEBUG MODE EN].
Then, Press [OK].
2. Press [MENU], you can see setup menu.
By pressing [Up key], select AF TEST.
By pressing [Right key], go into AF TEST menu.
By pressing [Down key], select FOCUS CORR.
now you can adjust shift amount by pressing [right key] or [left key].
(*Don't touch AF Area Test.)
after changing the value, Press [OK] to save.
3. Test your camera that Focus is corrected.
(repeat step 2. till you satisfy the result.)
4. Power OFF
While pressing [AE-L]+[INFO], turn the camera on.
Firmware is desplayed on LCD.
Press [MENU]->[MENU]->[INFO] within 5 seconds.
You can see DEBUG mode screen.
By pressing [Right key],Make [DEBUG MODE EN] to [DEBUG MODE DIS].
Then, Press [OK].
5. Go out and enjoy!!