PDA TOOLBOX 的問題請教

我在設定 radio buttons時都不能正常工作
下面一篇是在討論區上和我一樣問題的文章
Each time I set up an application using the radio buttons, I get unwanted data. i.e. two radio buttons one is yes and the other is no. They feed into a table of two columns, one for yes and one for no. If the answer is yes the no column has a bunch of 0's and other characters in it.
Is there a way not for this to occur or possibly group the radio button responses into one column?
  
下面一篇是TOOLBOX作者的回覆
Hi,
In PDATB a few revisions back, the Checkbox?and Pushbutton(Radio) used to be declared as the same Name for the Field ID, and you used to get the type of response that you desire in a single field on a table.  
  
The ability to group these items came along in ver 3.x? and we were no longer able to use the same name (duplicate) Field ID's for these items. I do not know how this change was implemented and so have no solution to offer.
  
Regards,
Paul Anderson
  
可是我不知道作者回覆的意思是什麼，可不可以請知道的人解釋一下呢?
也想請教一下站長是否有一樣的問題出現? 要如何解決?