[轉貼] Pentax DSLR 工程模式 (調焦)

阿輝

Pentax DSLR 工程模式 (調焦)

K10D
http://forums.dpreview.com/forum ... mp;message=22013971

PFC
http://forum.pentaxfans.net/showthread.php?t=44397
http://forum.pentaxfans.net/showthread.php?t=44438

Here's How-to-adjust-focus.

1. Your K10D' firmware version must be 1.10.

2. Test shot for focus trouble.

3. Turn the camera OFF.
    While pressing [PLAY]+[OK], Turn the camera ON.
    You can see firmware version on LCD screen.

4. Firmware version is appeared,
   then press [Fn]->[Fn]->[INFO]->[MENU] within 5 seconds.
  You get service menu!!!

5. by pressing [right key]
   ,Make DEBUG MODE to DEBUG MODE .
   then press [OK].
   (save and LCD will be black out)

6. Press [MENU] and go to SETUP tab.
    then, Press [Up key], you can see TEST MODE.

7. Select AF TEST menu. now you have AF correction menu.
    If you have Front-focusing, reduce the value.
    If you have back-focusing, increase the value.
    after adjust some value, press [OK] and quit out of setup menu.

8. TEST for focus, find out that focus is correct.
    (repeat this from 6 for correct focus.)
9. Go to service menu(step 3,4).
   Make DEBUG MODE to DEBUG MODE .
   then press [OK].(save and LCD black out)

10. Go out and enjoy nice photos!!!

==================================================

DL, DS, DS2, K100D
http://forums.dpreview.com/forum ... mp;message=22023704

PFC
http://forum.pentaxfans.net/showthread.php?t=44397
http://forum.pentaxfans.net/showthread.php?t=44438

STEP
1. Power OFF
   While pressing [AE-L]+[INFO], turn the camera on.
   Firmware is desplayed on LCD.
   Press [MENU]->[MENU]->[INFO] within 5 seconds.
   You can see DEBUG mode screen.
   By pressing [Right key],Make [DEBUG MODE DIS] to [DEBUG MODE EN].
   Then, Press [OK].

2. Press [MENU], you can see setup menu.
   By pressing [Up key], select AF TEST.
   By pressing [Right key], go into AF TEST menu.
   By pressing [Down key], select FOCUS CORR.
   now you can adjust shift amount by pressing [right key] or [left key].
   (*Don't touch AF Area Test.)
   after changing the value, Press [OK] to save.
3. Test your camera that Focus is corrected.
   (repeat step 2. till you satisfy the result.)
4. Power OFF
   While pressing [AE-L]+[INFO], turn the camera on.
   Firmware is desplayed on LCD.
   Press [MENU]->[MENU]->[INFO] within 5 seconds.
   You can see DEBUG mode screen.
   By pressing [Right key],Make [DEBUG MODE EN] to [DEBUG MODE DIS].
   Then, Press [OK].
5. Go out and enjoy!!