如何重設 (reset)3COM 無線 AP(3CRWE554G72T)

kermit

手邊有一顆3COM AP，之前借給同事，歸還後一直閒置，直到今天才又拿出用。

但問題來了，說明書不見了，AP的密碼與設定均被改變，看樣子得reset才能解決。

但這款AP號稱無『硬reset孔』，只能用以下步驟來重設，網路上找到的(PCDVD四年前的苦主所貼)

就是先拔掉電源，拿一條網路線，一端接DSL/WAN埠，另一端接任一LAN port，插上電源，等30秒....

照著做果然與苦主一樣沒下文，後來發現問題出在步驟三"Using a straight through Ethernet cable..."，這裡的

cable原來指的是連接ADSL Modem與AP(或HUB, 或電腦)的網路線(有跳線)，而非一般的網路線。

弄對了後，後續步驟就照做，完成後192.168.1.1進得去了

<http://www.pcdvd.com.tw/showpost.php?p=1081019767&postcount=1>
1 Remove power from the Router.
2 Disconnect all your computers and the cable/DSL modem from the Router.
3 Using a straight through Ethernet cable, connect the Ethernet Cable/DSL port on the rear of the Router to any one of the LAN ports.
4 Re-apply power to the Router. The Alert LED will flash as the Router starts up, and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started to flash slowly, remove power from the Router.
5 Remove the cable connecting the Cable/DSL port to the LAN port, and reconnect one of your computers to one of the Router LAN ports.
6 Re-apply power to the Router, and when the start-up sequence has completed, browse to:
http://192.168.1.1
and run the configuration wizard. You may need to restart your computer before you attempt this.
7 When the configuration wizard has completed, you may reconnect your network as it was before.

[ 本文最後由 kermit 於 2008-9-24 15:26 編輯 ]